Parr-instrument TDM Manual do Utilizador descarregar pdf

Installation Instructions for Tachometer

Display Module (TDM) in 4848 Reactor

Controller

555M

Meter installation in 4848 Reactor Controller

1. Unplug the power cord of the 4848 controller. Re-

move the (2) screws located on the top/front cover at

the rear corners of the controller. Gently lift the cover

forward, which is hinged at the bottom, taking care

not to apply tension on any internal wiring.

2. If applicable, remove and discard the black hole

plug on the sloped front panel above the "RPM" text.

This can be done by pinching the clasps on the back

of the plug from the inside of the front plate.

3. Insert the TDM (2084E) through the panel cutout,

from outside in, making sure the rubber gasket is

on the outside of the controller front panel. (If wires

are preinstalled, remove the terminal connector by

releasing the tabs on the sides of the module and

gently pulling the terminal connector off. Reference

photos below.) Slide the white mounting bracket

onto the module with the mounting screws pointing

towards the front panel. Slide the mounting bracket

forward until it touches the controller panel. The

clasps on the mounting bracket should align with the

groves on the module. Gently tighten the screws un-

til the module is held into place. (If removed, reattach

the terminal connector.)

Terminal Connector Removal

1 2 3 4 5 6 7 8

Resumo do Conteúdo

Página 1 - Controller

Installation Instructions for Tachometer Display Module (TDM) in 4848 Reactor Controller555MMeter installation in 4848 Reactor Controller1. Unplug th

Página 2 - TDM Installation

TDM InstallationParr Instrument Company2Meter Installation Diagram4848 Inside ViewMeter installation in 4848 Reactor Controller (Continued)

Página 3

TDM Installationwww.parrinst.com3Wiring installation in 4848 Reactor Controller1. If applicable, remove the black hole plug on the back of the contro

Página 4

TDM InstallationParr Instrument Company4Wiring installation in 4848 Reactor Controller (Continued)4. Attach the 4-pin edge connector from the A2106E

Página 5

TDM Installationwww.parrinst.com5Wiring installation in 4848 Reactor Controller (Continued)8. Find the remaining black wire #2 from the kit and attac

Página 6

TDM InstallationParr Instrument Company6Keys command:1. Press “SET” to select 2. Press return key move to next operation mode3. Up/Down arrow keys

Página 7

TDM Installationwww.parrinst.com7Press “SET” and releaseSelect type/value Select type/value CommentAt OFF Auto Tuning ON/OFFPID0 0 The 0th PID Parame

Página 8 - Revision 04/09/12

Revision 04/09/12

Comentários a estes Manuais

Sem comentários

Parr-instrument TDM Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Sensores Parr-instrument TDM. Parr Instrument TDM User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Parr-instrument TDM